Nevion Multicon User Manual download pdf (Page 67)

Hardware Information 67

ID: man-multicon Multicon Manual Rev. L

12.8.1 Factory default procedure

Factory image contains the Multicon software at the time the Multicon was produced. If the cur-

rent software on Multicon is not working as expected, the factory image can be activated. This

image can be used to upgrade Multicon to a working software version.

Reset conﬁguration to factory default functionality can be used, if your conﬁguration (levels, vir-

tual routers, salvos, button conﬁgurations, serial ports etc.) has been corrupted, or you want to

start from scratch.

Follow this procedure to enable factory default image and/or reset conﬁguration

1. Eject Multicon card from the frame or N-Box

2. Set dip switch 2 and/or 3 on, depending on your needs

3. Reinsert card and observe LED status

4. When the three ﬁrst LEDs are oﬀ and the fourth (at bottom) LEDs is yellow, eject Multicon

card again

5. Set dip switches back to default

6. Reinsert card

Use either Nevion Conﬁgurator or webpages to start conﬁguring the Multicon again.

12.9 Flashlink Card Hot Swap

All Flashlink cards are designed to be hot swappable. No special commands or sequencing is

necessary to perform the swap, just extract the card to be replaced from the Flashlink frame and

insert the new card.

Note: All setup is restored to the state of card last seen in the same

position, if and only if the new card is of the same type and the previous

card was extracted after the last controller reset. In all other situations,

the internal card state is considered correct and not touched.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 82 83

No comments

Nevion Multicon User Manual Page 67