Nevion Multicon User Manual download pdf (Page 35)

Web Interface 35

ID: man-multicon Multicon Manual Rev. L

Figure 7.7 Multicon web date and time setup

7.4.3 Flashlink

This tab is for Flashlink use only and described in Section 8.4.

7.4.4 Debug Terminal

Debug terminal is for Flashlink use only and described in Section 8.5.

7.4.5 SNMP Setup

Multicon includes an SNMP agent. This means that all the Flashlink modules, VikinX Sublime

and VikinX Modular can be accessed from a higher level third-party management system. The

SNMP MIB information is described in a separate manual, Multicon SNMP Data Model.

For Flashlink full monitoring and conﬁguration of all modules is supported. For VikinX Sublime

conﬁguration of router crosspoints is supported. For VikinX Modular full monitoring and conﬁg-

uration is supported.

Setup is done through the web interface. This is found under the CONFIG tab and SNMP settings.

Figure 7.8 Multicon web SNMP settings

There are two global settings for traps:

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 82 83

No comments

Nevion Multicon User Manual Page 35