Nevion VikinX Sublime series Rev.G User Manual download pdf (Page 10)

VikinX Sublime Optical Routers Rev. G

nevion.com | 10

Figure 1: Service connectors.

SYNC:

Synchronization signal (in). Black burst/composite/tri-level sync

reference input with passive loop-through for vertical interval

switching.

LOOP:

Synchronization signal (out). Loop-through of SYNC input.

NCB IN:

Network Control Bus Input. The protocol of this bus is described in a

separate manual.

NCB OUT:

Network Control Bus Output.

ETHERNET:

10/100Base-T Ethernet bus for external router control.

RS 232:

RS-232 for external control protocols.

POWER A:

±15VDC power socket.

POWER B:

±15VDC power socket, redundant supply.

CONFIGURATION:

Configurations switch. See Chapter 3 for further descriptions.

2.5.1.1 Power Supply pin-out

The DE9 male sockets for the power connection on Sublime routers and Control Panels

have the following pin-out;

Pin #

Description

GND

Not connected

+15VDC

Not connected

-15VDC

Not connected

2.5.2 64x64 versions

The 64x64 Sublime routers with optical I/O have the same service connections on the rear

of each product, as above, except for the power connectors:

Power A (48 VDC):

+48VDC power connector

Power B (48 VDC):

+48VDC power connector, redundant supply

2.5.2.1 Power Supply pin-out

The DSUB 2V2P power sockets for Sublime routers using SL-PWR-300 have the following

pin-out;

Pin #

Description

Socket

+48VDC

Note that any VDC supplies with output voltage between +36VDC and +72 VDC, with sufficient power, may be applied to the

router.

The router is supplied with inverse diodes. This means that in a redundant power supply application the router will pull its

entire load from the PSU with the highest output voltage.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 36 37

Comments to this Manuals

No comments

Nevion VikinX Sublime series Rev.G User Manual Page 10

Comments to this Manuals

Related products and manuals for Routers Nevion VikinX Sublime series Rev.G