Nevion Nordre Kullerød 1 3241 Sandefjord Norway Tel: +47 33 48 99 99 nevion.com FRS-HD-XMUX4 HD/SD-SDI Frame Synchronizer with 4x AES I/O Us
FRS-HD-XMUX4 Rev. C nevion.com | 10 OPT/EL OPT/EL Optical / Electrical input SDO1PROC SDI OUT 1 Off: through mode On: processed mode In thro
FRS-HD-XMUX4 Rev. C nevion.com | 11 Figure 3: Multicon GYDA information page 3.3 Connections Figure 4: FRS-HD-XMUX4-C1 backplane left:
FRS-HD-XMUX4 Rev. C nevion.com | 12 The backplane for the FRS-HD-XMUX4 is labeled FRS-HD-XMUX4-C1. The table below shows the connect
FRS-HD-XMUX4 Rev. C nevion.com | 13 4 Operation 4.1 Front panel LED indicators Special conditions for the LEDs The locate command will make
FRS-HD-XMUX4 Rev. C nevion.com | 14 4.2.1 Functions of 8pin modular jack GPI name Function Pin # Mode Direction Status General error status
FRS-HD-XMUX4 Rev. C nevion.com | 15 5 Functional description 5.1 Data path HD/SD-SDI input is selected from either optical or electrical in
FRS-HD-XMUX4 Rev. C nevion.com | 16 Automatic selection mode Figure 6: Multicon GYDA view of the input selection If the Video in mode select
FRS-HD-XMUX4 Rev. C nevion.com | 17 5.4.1 Frame sync mode If a sync input (B&B or Tri-level) is present, the frame synchronizer will outp
FRS-HD-XMUX4 Rev. C nevion.com | 18 The picture will first freeze for <hold time> and then go to video generator. The output is now ref
FRS-HD-XMUX4 Rev. C nevion.com | 19 The “On” tick-box will show the label at all times, while the “Off” will turn the label g
FRS-HD-XMUX4 Rev. C nevion.com | 2 Nevion Support Nevion Europe P.O. Box 1020 3204 Sandefjord, Norway Support phone 1: +47 33 48 99 97 Suppo
FRS-HD-XMUX4 Rev. C nevion.com | 20 5.9 Video output selection The board has four outputs organized as two pairs, each consisting of one inve
FRS-HD-XMUX4 Rev. C nevion.com | 21 5.12 Audio delay An audio delay relative to the video output can be specified commonly for a
FRS-HD-XMUX4 Rev. C nevion.com | 22 eight stereo channels for re-embedding, four AES outputs, and a separate data output for data recovered f
FRS-HD-XMUX4 Rev. C nevion.com | 23 audio based on the delay setting for video and audio. This is useful if the SDI-in and AES has a common c
FRS-HD-XMUX4 Rev. C nevion.com | 24 The sum products ( (L+R)/2 and MS) are reduced in level by 6 dB to avoid any possibility
FRS-HD-XMUX4 Rev. C nevion.com | 25 6 RS422 commands 6.1 FLP4.0 required commands Block Blk# Commands Example Response Control - - ? ? produc
FRS-HD-XMUX4 Rev. C nevion.com | 26 misc 0 - NOT AVAILABLE BY COMMAND. ONLY FOUND in Conf 0 prog | fin ' ' | ovr Misc info prog i
FRS-HD-XMUX4 Rev. C nevion.com | 27 next pri level, and how long an input with a higher priority should be present before we consider it repa
FRS-HD-XMUX4 Rev. C nevion.com | 28 use24 on/off: This is only valid for SD and selects between 24bit and 20bit sound. del off/on delay12 d
FRS-HD-XMUX4 Rev. C nevion.com | 29 vary with incoming video standard, see dly 0 above. vgen 0 cbar | mcbar | chkfield | white | yellow | cya
FRS-HD-XMUX4 Rev. C nevion.com | 3 Contents 1 Product overview ...
FRS-HD-XMUX4 Rev. C nevion.com | 30 track selects whether AES delay tracks the video delay. aprc 0-11 lr | rl | ll | rr | nlr | lnr | mm | ms
FRS-HD-XMUX4 Rev. C nevion.com | 31 6.3 Commands intended for debug/lab use only Block Blk# Commands example Response Control spi - on | off
FRS-HD-XMUX4 Rev. C nevion.com | 32 General environmental requirements for Nevion equipment 1. The equipment will meet the guaranteed perform
FRS-HD-XMUX4 Rev. C nevion.com | 33 Product Warranty The warranty terms and conditions for the product(s) covered by this manual follow the G
FRS-HD-XMUX4 Rev. C nevion.com | 34 Appendix A Materials declaration and recycling information A.1 Materials declaration For product sold int
FRS-HD-XMUX4 Rev. C nevion.com | 4 1 Product overview SDI OPTICAL INSDI ELECTRICAL INSDI OUT16 ch AudioDe-embedder16 ch Audio EmbedderAudio x
FRS-HD-XMUX4 Rev. C nevion.com | 5 1.3 Key features 4 x HD-SDI outputs 4 x AES I/O HD/SD video support, including DVB-ASI in through
FRS-HD-XMUX4 Rev. C nevion.com | 6 2 Specifications Optical SDI input Data rate optical: 270 – 1485 Mbps Sensitivity - SD-/HD-SDI (270/1485
FRS-HD-XMUX4 Rev. C nevion.com | 7 AES I/O Number of inputs/outputs 4 Connectors WECO Return loss 110R +/-20% 0.1MHz – 6.144MHz Output jitter
FRS-HD-XMUX4 Rev. C nevion.com | 8 3 Configuration The board can be configured both manually and through the Network control system Multicon
FRS-HD-XMUX4 Rev. C nevion.com | 9 3.1.3 DIP switch functions Note that the left DIP switch of the horizontal DIP package is number 1. The
Comments to this Manuals